Curecon W

  • Water Dispersed Resin Curing Compound Compliance: AS3799/RTA3203

Product Description

Curecon W is a water based resin curing compound used to retain moisture in concrete for effective curing. Used for all concrete but specifically designed for use in mass concrete structures such as roadwork, bridgework and runways

Advantages

  • ƒ Non-flammable/ non dangerous goods classification
  • ƒ Non toxic
  • ƒ Tack free when dry
  • ƒ Rapid film formation
  • ƒ Volatile ingredients comply with air pollution requirements of photo-reactive compounds
  • ƒ Reduces surface shrinkage and cracking by eliminating moisture loss from exposed surfaces.
  • ƒ Eliminates the need for damp hessian, sand or polythene
  • ƒ Increases concrete strength and dusting resistance

Design Criteria

The coating should be applied at a coverage rate of 5m2/litre. To achieve the correct curing propertiesand moisture retention according to AS/RTA standards, Curecon W must be applied at the above stated coverage rates. Curecon W contains a green fugitive dye to ensure a uniform application is achieved. Curecon W dries as a clear film on the surface.

Colour Light green milky liquid
Viscosity >0.050Pa.s
Specific Gravity  0.95-1.0
Flash point  Not Applicable achieved. Curecon W dries as a clear film on the surface
Coverage 5M²/litre using a spray applicator-do not brush
Clean-up Water when wet. Kerosene, fuel or solvent525 (allows reemulsification with water) when dry
Drying Time onconcrete ½-1 hour at 25°C 50% RH

Application Instructions

Curecon W should be evenly sprayed onto the surface over the freshly laid concrete as soon as possible after final trowelling. Ideally Curecon W should be applied as soon as the surface bleed water has evaporated. In all cases Curecon W should be applied at a coverage rate not greater than 5M² per litre.

Availability

CodePack
185015-0020 Curecon W 20L
185015-0020 Curecon W 200L
185015-1000 Curecon W 1000L

Downloads